Announcement

Collapse
No announcement yet.

error when starting DM780 only

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • error when starting DM780 only

    When I start the whole software suite it works fine. I tried to open DM-780 by its self and it gives me errors that the ****.dll can't be found. This error does this three time then exits. Has it changed where you can't run dm780 by its self? Log Book does the same thing except different .dll error messages.

    Thanks
    Gerald KC6CNN
    Last edited by kc6cnn; 10-12-19, 11:15.
    sigpic
    KC6CNN

    Gerald Manthey

    .

  • #2
    DM-780 opens and runs fine by its self here. v6.6.0.236

    73, Charlie, K0LAF
    73,
    Charlie, KØLAF

    Comment


    • #3
      HMM, okay. I am using 6.6.0.237 on windows 10 with newest update.
      I will delete it and try reloading it again. I had loaded it over after the first error.
      Thank you Charlie for your help and reply.
      Gerald
      sigpic
      KC6CNN

      Gerald Manthey

      .

      Comment


      • #4
        I deleted all I could find, including from reg. I downloaded a copy of the newest version and loaded it. I must of missed something because it knew my radio call sign and I did not have to inter the registration key. But now DM780 and log book will not open at all, even if rig control is open. Guess I better go look around for more stuff to delete to make it a new install. unless someone can tell me where I might find a older copy to load and try.
        sigpic
        KC6CNN

        Gerald Manthey

        .

        Comment

        Working...
        X