Announcement

Collapse
No announcement yet.

Takes Two Attempts to Connect to Rig

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Takes Two Attempts to Connect to Rig

    Ever since I "upgraded" to Windows 10 ver 1809 it takes two attempts to connect to the rig after PC boot up. Connection fails on initial launch of HRD, but hitting <reconnect> works every time. And once I have connected I can stop and start HRD and the connection works first time.
    Rig is a K3S and PC and all hardware remain the same. Did not have this problem with previous version of Windows 10.
    Anyone else experiencing this, or have a solution?
    73, Jim - N4ST
    __________________________________________________ __
    3GHz Core 2 Duo, 8GB, Win10 64-bit, TASCAM US-322, FTDI, Ten-Tec Omni VII, HRD 6.2.3.410

  • #2
    Jim, just for info... I was unable to connect my ic-7410 to hrd until I got a ac powered usb hubport between the radio and my computer... just curious if you are or are not using one??? Ski, n7soc

    Comment


    • #3
      I reinstalled my USB drivers and fussed around, rebooted, etc. and things started working. I should have re-posted that it was "fixed", but I was so unsure as to the specifics of the fix that I didn't.
      73, Jim - N4ST
      __________________________________________________ __
      3GHz Core 2 Duo, 8GB, Win10 64-bit, TASCAM US-322, FTDI, Ten-Tec Omni VII, HRD 6.2.3.410

      Comment

      Working...
      X